Hardness Tetser 206 EX

Hardness Tetser 206 EX


Test BlocK:

Semi-automatic Hardness Tester. Rockwell conforms to ASTM E 18 and ISO 6508. Load cell system. ** From our showroom **.

206EX is a user friendly hardness test for fast and easy measurements:

  • Load forces are applied directly on the measuring axis through two incremental dynamometric load cells.
  • There are no ratio load forces nor lever, eliminating problems associated with dead weight systems on traditional testers.
  • This hardness tester is very accurate, it is not affected by any structural deflection, misalignment or vibration and can also operate in an inclined position.
  • It doesn't need to be leveled.

Main control LCD panel in front of the measuring head for setup of test parameters, including powerful software and electronic:

  • Simultaneous view of 2 scales, the one of the test and the one chosen from the list of conversion scales.
  • Conversion values for all hardness scales HR, HB, HV, HSD, HK, HRN, HRT, N/mm.
  • Precise test settings: Check load applied correctly. Select dwell time. Calibration for direct and indirect method conform to ASTM E 18 ISO 6508.
  • Dynamic results: Simultaneous view of the range of results for statistic. Results average update at the last measure. Statistic CP CPX CX Histogram and number of test corresponding to tollerance values (Lo, Hi, Ok). Create 10 file record data each one 350 measures.
  • Unique performances: Temperature measure C° usefull for certificate test conform to ASTM E 18 ISO 6508. Depth of indentation in 0,01 micron. Acoustic signal for dwell time and for preload. Printer connection output RS 232C or converter to USB. Back light LCD display 128 x 64 pixel. Touch key pad board IP 64 protection. Powered by rechargeable battery for 100% portability of the hardness tester (OPTION).



Preload: 98.1 N (10 kgf)
Rockwell: 588.4 - 980.7 - 1471 N (60 - 100 - 150 kgf)
Vickers/Knoop: 98.07 - 588.4 - 980.7 N (10 - 60 - 100 kgf)


Rockwell: HRC - HRA - HRD - HRB - HRE - HRF - HRG - HRH - HRK
Vickers/Knoop: Generate indentation
Temperature: Measure range from - 40.0 to + 80.0 °C


Accuracy: Better than 1%
Temperature range: From 10 °C to 35 °C
Data output: RS232 C (As option USB)
Power supply: 110 or 220 V / 50÷60 Hz
Software: Affri - OMAG
Principle of operation: Dynamometric Load Cell
Conformity standards: EN-ISO 6506-2 / EN-ISO 6507-2 / EN-ISO 6508-2 / ASTM-E18 / ASTM-E10 / ASTM-E384 / ASTM-E103 / JIS
Height capacity: 215 mm / 8.5
Depth capacity: 190 mm / 7.5
Tolerable weight: 2000 kg
Fields of use: For all metals, iron, steel, tempered steel, cast iron, brass, aluminium, copper and metal alloys with more than 0.6 mm thickness..
Dimension (L x W x H) 50 x 60 x 100 Centimetre
Weight 65 Kilogram